|
|
Delta 50-211 4-Inch Dust Adapter for 37-070
|
List Price: $38.46
Our Price: $21.85
You Save: $ 16.61 ( 43% )
Availability: Usually ships in 24 hours
Manufacturer: Delta
|
Average Customer Rating:  
|
|
Binding: Tools & Hardware
Brand: Delta
EAN: 0069554502118
Feature: Adapts Delta 37-070 Bench Jointer for dust collection
Label: Delta
Manufacturer: Delta
Model: 50-211
Publisher: Delta
Studio: Delta
|
|
|
Features
|
Adapts Delta 37-070 Bench Jointer for dust collection
Allows you to maintain a cleaner, safer work environment
Installs easily over existing dust chute for quick set up
Outlet fits 4-inch dust collector hose for efficient chip collection
|
|
|
|
|
|
|
|
|
Spotlight customer reviews:
|
Customer Rating:
Summary: works great once installed
Comment: Installation wasn't easy as the two upper bolt holes were way off. I also tried installing it upside down, but had the same problem. Since it is made of sheet metal I used a rattail file to elongate the holes. Eventually it installed. I also used weather stripping along the sides connecting to the tabs. Hooked it to a shop vacuum and it works great. No loose dust at all.
Customer Rating:
Summary: Good product but a bit rough
Comment: There are two ways to install this, as other reviewers have noted. I elected to install mine so that the chute didn't extend below the tabletop. The screw holes were a little off position, but it went together all right. I don't know why the product has the little wings extending about 1.2 inch to each side, unless the designer wanted me to bend them down around the sides (another reviewer did that). The way the product is listed is confusing, because the jointer I have is the JT160, not the 37-070. Go figure. The finish on this adapter is good. Also, the product description doesn't say that this adapter is made of steel, not plastic, which to me is a plus. Considering the amount of shavings my jointer puts out, this item, and some kind of dust collector, are mandatory.
Customer Rating:
Summary: Works great!
Comment: Easy to install, works great with my dust collection system. It only extends below the jointer if you install it upside down!
Customer Rating:
Summary: works, but keeps jointer from sitting flat
Comment: The dust adapter works as described. They fail to mention, however, that it extends below tabletop level somewhat, so the jointer must be placed at the edge of the bench so the adapter can hang over. This also makes it hard to store the jointer on a shelf, or the floor. What were they thinking?
Customer Rating:
Summary: Easy to install.
Comment: It took about three minutes to pull off two torx screws, two phillips screws, hold the adapter in place, and put the four screws back in. I then folded the wings on the sides with a rubber mallet and this seems to have sealed it well. My only gripe is that it should have something akin to weather stripping to seal it though it's adequate as delivered.
|
|
|
Editorial Reviews:
|
Connectors for Jointers
|
|
|
|
|
|
