|
|
All in One Clamp RP 8-Inchx 9-Inch Router Plate
|
List Price: $33.99
Our Price: $27.99
You Save: $ 6.00 ( 18% )
Availability: Usually ships in 24 hours
Manufacturer: E. Emerson Tool Co
|
Average Customer Rating:  
|
|
Binding: Tools & Hardware
Brand: Emerson Tool Co
EAN: 0894837000094
Feature: Router tracks perfectly along the straight edge
Label: E. Emerson Tool Co
Manufacturer: E. Emerson Tool Co
Model: RPXXX
Publisher: E. Emerson Tool Co
Studio: E. Emerson Tool Co
|
|
|
Features
|
Router tracks perfectly along the straight edge
Base locks onto the t-track
Keeps your router in control
Eliminates router kick for a smooth cut
Crystal clear polycarbonate to see your cuts
|
|
|
|
|
|
|
|
|
Spotlight customer reviews:
|
Customer Rating:
Summary: great tool
Comment: I got this several months ago. With my cordless circular saw, it has been a great convenient, mobile set-up.
Customer Rating:
Summary: Junk
Comment: First, none of the many pre-drilled holes fit my very common Porter Cable router. Second, although there is a hole for a screw to attach it to the T-track in the clamp, one is not provided. But thirdly and most frustratingly, the slot in the plastic for the clamp's track to go through is too tight so it gets stuck. I twice got my router halfway through the piece and simply could not budge it any farther. I threw the damn thing away, another $20 wasted.
Customer Rating:
Summary: no slide
Comment: the router and circular saw slide are hard to attach to the saw in particular. both do not slide on the rail with out forcing them which results in a bad cut or rout job. would not buy these again or recommend them to anyone.
Customer Rating:
Summary: ATLNorm
Comment: I bought the router plate, the wide jaws and the 50" clamp a few months ago, for a particular project requiring lots of dadoes in MDF. The whole system works as advertised, and is well worth the modest cost. A couple of notes--I probably over-tightened the clamp, causing a piece of the cam-lever to break. It hasn't ruined the clamp, but I assume the overall clamping pressure has been diminished. Second, I used a cheap router bit and pushed it so hard that I melted the router plate. That said, I sent a simple email to the manufacturer inquiring about replacement parts (and explaining the problems, even admitting my responsibility), and in less than two hours, the company responded with an offer to replace the parts (no cost). That's customer service.
Great product, and a great company that stands behind its product.
Customer Rating:
Summary: A definate improvement over the clamp by itself
Comment: I used this with an all in one clamp I purchased at another store. I was cutting a 1/4 inch dado into 3/4 oak ply. I made test cuts with and without the plate using a 2 1/4 HP Bosch router. I found the cuts with the plate much easier. Installaton was a snap because there were predrilled holes for my router base. Simple product to use, and it make the job a lot easier. Please take into account that I am a beginning woodworker, those with or experience may not need this type of tool, but for me, this worked well, and with little setup. This makes the dado cuts so easy that I am going to forget using a dado blade in my tablesaw. I would highly recommend. Good luck.
|
|
|
Editorial Reviews:
|
The E. Emerson Tool Company RP All-in-One 8-by-9-Inch Router Plate tracks perfectly along straight edges and eliminates router kicks to create smooth, steady cuts. You can watch your cuts through the crystal clear polycarbonate surface, and all you have to do is lock the plate into your T-track for a secure fit.
|
|
|
|
|
|
