|
|
Porter-Cable 75301 Height Adjuster
|
List Price: $38.47
Our Price: $22.06
You Save: $ 16.41 ( 43% )
Availability: Usually ships in 24 hours
Manufacturer: Porter-Cable
|
Average Customer Rating:  
|
|
Binding: Tools & Hardware
Brand: Porter-Cable
EAN: 0039404129666
Feature: Height adjuster for use with table routers
Label: Porter-Cable
Manufacturer: Porter-Cable
Model: 75301
Publisher: Porter-Cable
Studio: Porter-Cable
|
|
|
Features
|
Height adjuster for use with table routers
Releases router motor and adjusts bit height
Clamp router motor
Make all your adjustments from above the router table
Weighs 1.4 pounds shipped; 1-year warranty
|
|
|
|
|
|
|
|
|
Spotlight customer reviews:
|
Customer Rating:
Summary: Works nicely
Comment: I use this device with a Rockler router table insert plate that replaces the Porter Cable factory base for the 980 series router. Rockler provides two holes in the aluminum insert plate that accommodate the height adjuster; one hole for the router lock clamp and one to adjust the height of the bit above the table. These holes line up precisely with the router's adjustment nuts. I get great accuracy and plenty of control with the large height adjuster handle. The micro-calibration washer that comes with the unit isn't very useful because of slight play in the router screw drive mechanism that adjusts the bit extension. I depend, instead, on a standard caliper to get the correct bit height.
Customer Rating:
Summary: 75301 Height Adjuster Review
Comment: Porter Cable should advertise this item more. It provides a good alternative and simplifies use of the router table. I would not have known it was available if I had not done so much searching on the internet. It performs well and is very cost effective.
Customer Rating:
Summary: Not enough holes- An Afterthought?
Comment: I bought the P-C 891 Router and the P-C 698 Table, supposedly compatible. I ordered the 75301 Height Adjuster because it looked like a great help for adjusting the motor height from above. But there are no HOLES in the TABLE to pass this Adjuster through! The folks at Porter Cable admit they forgot to provide holes for the 890/891/892 router motor, and they are very nice about this, but told me yes, I really have to drill two holes in the table to use this gadget! The table comes with plenty of other holes to accomodate the attachments, motors, etc. so it seems a shame that they did not make two holes for the ht. adjuster. Actually it's not hard to reach underneath to open and close the locking lever and twist the original height adjuster. I just don't know if I want to drill out the table yet.
Customer Rating:
Summary: Time-saving Height Adjuster
Comment: This product makes adjusting router height virtually effortless. Insert it through one hole in the table and unlock the clamp, them insert it through the other hole and adjust the height while watching the callibrated dial rotate on the table. Then return to the first hole to lock the clamp again. No need to crawl under the table and find the adjustment screws.
|
|
|
Editorial Reviews:
|
Used to release the motor, adjust bit height and clamp the motor from above the router table.
|
|
|
|
|
|
